18
49-80520-7
FINALIZE INSTALLATION
• Refer to the operating instructions to test all controls.
12
Installation Instructions
INSTALL FILTERS
• Remove protective film covering the filters.
• Insert the filter into the “C” clips mounted to the top of
the vertical front panel.
• Tap the filter against one side to align with outside
opening.
• Pull the filter down into the lower slots at the bottom
of the filter support.
• To remove the filters, grasp the handle, push the filter
up, and pull forward.
11
“C” Clip
-XQFWLRQ%R[
Filter
Support
Filters
Troubleshooting Tips
Save time and money! Review the chart below first and you
may not need to call for service.
Problem
Possible Causes
What To Do
Fan does not operate
A fuse may be blown or a
• Replace fuse or reset circuit breaker.
when the switch is on circuit
breaker
tripped.
The blower connector is loose
• Disconnect power to the unit. Remove the filters
or not plugged into its mating
and look up at the blower. If the blower connector
connector.
plug is loose or you see the connector dangling,
the installer failed to plug it in securely. Although it
is a blind connection, it is easy to plug in. See the
Installation Instructions in this manual for the plug
location and how to plug the connector in.
Fan fails to circulate air Excessively soiled filters.
• Remove the filters, clean if necessary and replace
or moves air slower than
them. If cleaning and replacing the filters does not
normal
correct the problem, call for service.
• Sufficient makeup (replacement) air is required for
H[KDXVWLQJDSSOLDQFHVWRRSHUDWHWRUDWLQJ&KHFNZLWK
local building codes, which may require or strongly advise
the use of makeup air. Visit GEAppliances.com for available
makeup
air
solutions.
Before you call for service…