49-80520-7
17
INSTALL DUCT COVERS
7RLQVWDOOWKHµGXFWFRYHUDORQH
• Place the 12” section of the decorative duct cover on
top of the hood.
• Secure the cover on the top of the hood with 4 screws
provided.
To install the 2-piece duct cover:
• Place the 2-piece duct cover on the top of the hood.
• Secure the bottom cover to the top of the hood with 4
screws provided. See illustration, page 16.
([WHQGWKHLQVLGHVHFWLRQXSZDUGVWRPHHWWKHFHLOLQJ
and ceiling bracket
• Secure the duct cover to the bracket with the 2 small
Phillips screws provided.
INSTALL MOTOR
• Align and engage the slots
in the blower assembly to
the 3 hooks at the rear of
WKHH[KDXVWRSHQLQJ
• Rotate motor upwards until it
aligns with the attachment
screw location.
• Secure the motor to
attachment bracket at
the front of the opening
with washer and screw
provided.
• Plug the motor
connector into the
mating hood connector.
Seethe illustration for
the hood connector location. Touch
the hood to locate and make the
connection.
IMPORTANT : Hold the connector so
the two square corner terminals are
at the top as you position the connector
to plug it in.
7
INSTALL FILTER SUPPORT
• Tip filter support into the rear of the hood.
• Insert support tabs into the slots at the rear of the
hood.
• Secure the support to the hood with screws as
shown..
10
9
CONNECT ELECTRICAL
Verify that power is turned off at the source.
WARNING:
If house wiring is not 2-wire
with a ground wire, a ground must be provided by the
installer. When house wiring is aluminum, be sure to use
8/DSSURYHGDQWLR[LGDQWFRPSRXQGDQGDOXPLQXPWR
copper connectors.
• Use wire nuts to connect incoming ground to green,
white to white, and black to black.
3XVKZLUHVLQWRMXQFWLRQER[DQGUHSODFHFRYHU%H
sure wires are not pinched.
8
Installation Instructions
Motor Attachment
Bracket
Motor Hooks
Insert Tabs into Slots
Install 2 Screws
D
Use UL Listed Wire Nuts
Ground
A
Remove
-XQFWLRQ%R[
Cover
B
Check that White, Black and
Green Hood Wires are Threaded
thru Small Hole in Bracket.
C
Insert Power
Conduit thru Strain
Relief and Tighten
White
Black