Care and cleaning of the vent hood.
www.GEAppliances.ca
Be sure electrical power is off and all surfaces are cool before cleaning or servicing any part of the
vent hood.
The hood has 2 metal reusable
grease filters.
The metal filters trap grease
released by foods on the cooktop.
They also help prevent flaming
foods on the cooktop from
damaging the inside of the hood.
For this reason, the filters must
ALWAYS
be in place when the
hood is used. The grease filters
should be cleaned once a month,
or as needed.
To clean the grease filters
, soak
them and then swish them around
in hot water and detergent.
Don’t use ammonia or ammonia
products because they will darken
the metal. Do not use abrasives or
oven cleaners. Light brushing can
be used to remove embedded dirt.
Rinse, shake and let them dry
before replacing.
They may
also be cleaned in an automatic
dishwasher.
To remove:
Grasp the filter handle and pull it
up, forward and out.
To replace:
Hold the filter at the bottom
with the handle.
Place the top end of the filter
against the inside front of the
hood.
Slide it up until it stops and
push the bottom end back
until it snaps into place.
Reusable Metal Grease Filters
To clean the hood surface, use
a hot, damp cloth with a mild
detergent suitable for painted
surfaces. Use a clean, hot, damp
cloth to remove soap. Dry with
a dry, clean cloth.
Do not use steel-wool pads or
other abrasive cleaners. They will
scratch the surface.
Painted Surfaces
(on some models)
If it ever becomes necessary to
replace the metal grease filters, they
may be ordered from your GE supplier.
Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
Care and Cleaning
5
Heavy-duty commercial filters may
also be used in place of the filters.
For 30” (76.2 cm) hoods,
order Kit no.
JXBF30SS
.
For 36” (91.4 cm) hoods,
order Kit no.
JXBF36SS
.
To order, call
1.800.661.1616
Do not use a steel-wool pad; it will
scratch the surface.
Shake bottle well.
Place a small amount of
CERAMA BRYTE
®
Stainless
Steel Cleaning Polish and
Conditioner on a
dry
cloth
or
dry
paper towel.
Clean a small area
(approximately 8” x 8” or
20.3 x 20.3 cm), rubbing with
the grain of the stainless steel if
applicable.
Dry and buff with a clean, dry
paper towel or soft cloth.
Repeat as necessary.
Stainless Steel Surfaces
(on some models)
To order:
To order CERAMA BRYTE
®
Stainless Steel
Cleaning Polish and Conditioner, please call
our toll-free number:
National Parts
Center . . . . . . . . . . . 1.800.661.1616
www.GEAppliances.ca
CERAMA BRYTE
®
Stainless Steel Cleaning
Polish and Conditioner . . . # PM10X313
