– 60 –
Stirrer Assembly
The Stirrer Assembly consists of a motor, blade,
and cover. The blade is motor-driven and rotates
on a pin embedded in the stirrer cover. The Stirrer
Assembly is located at the top of the oven cavity.
To remove the stirrer blade:
Note:
It is not necessary to remove the stirrer motor
when removing the stirrer blade.
1. Disconnect power from the microwave oven and
open the door.
2. Remove the 2 Phillips-head screws that attach
the cover to the oven cavity.
3. Lower the left side of the cover approximately
1 inch, then slide it to the left and remove the
cover from 2 tabs located on the right.
Tab
Tab
Stirrer Cover
4. Lift the stirrer blade off the pin embedded in the
cover.
Blade
Disconnect
Stirrer Motor
Stirrer Blade Hub
Caution:
When installing the stirrer motor,
misalignment of the stirrer blade hub can damage
the stirrer cover. Before installing the stirrer motor,
use a screwdriver inserted into the stirrer blade hub
to pre-align the square drive of the stirrer blade to
allow engagement of the motor shaft.
The stirrer motor has an approximate resistance
value of 120
.
To remove the stirrer motor:
Note:
It is not necessary to remove the stirrer blade
when removing the stirrer motor.
1. Remove the Air Tunnel Cover. (See
Air Tunnel
Cover
.)
2. Disconnect the stirrer motor wire harness.
3. Remove the 2 Phillips-head screws that attach
the stirrer motor to the top of the oven.
4. Lift the left-side of the stirrer motor, then remove
it from the oven.
