GE 5448623, Basic Service Manual

Page: 98 / 289

System Setup
3-26 Venue 50 – Basic Service Manual
5447566-100 English Rev. 7
Connect a probe (continued)
Follow these steps to connect a probe:
1. Place the probe’s carrying case on a stable surface and
open the case.
2. Carefully remove the probe and unwrap the probe cable.
3. DO NOT allow the probe head to hang free. Impact to the
probe head could result in irreparable damage.
4. Before connecting the probe:
a. Do a visual check of the probe pins and system sockets.
b. Remove any dust or foam rests from the probe pins.
c. Verify the probe and the probe cable for any visual
damage.
5. Plug the probe connector into the probe port on right side of
Venue 50 with the label facing the front.
Figure 3-16. Connect a probe
6. Carefully position the probe cable so that it is free to move
and is not resting on the floor.