9
Installing a case tamper switch
If your module is easily accessible, you may consider adding a case tamper detection switch. This switch
activates an alarm or trouble signal (depending on panel programming) when the module cover is removed.
1. Slide the reed switch into the plastic holder on the module backplate (see
Figure 5
).
Figure 5. Installing a case tamper switch
2. Connect a reed switch (with EOL resistor) to any unused hardwire input on the panel. For the EOL
resistor value, see the control panel installation manual.
3. Press the magnet into the tabs located on the module cover. Next, press the magnet clip over the
magnet until the clip locks into place (see
Figure 5
).
Module backplate
Module cover
To zone input
EOL resistor
Magnet clip
Magnet
