GE Security Legend IP, Installation Manual

Page: 56 / 82

Legend IP
Installation Manual
48
Passcodes off by default
Legend IP domes ship with the passcodes turned off. When you enter the programming interface for the first
time during installation and go to the
Passcode page under the Setup menu, the passcode fields are blank.
Blank passcode fields mean the passcodes are turned off (disabled). You can choose to enter passcodes into the
blanks. This turns passcodes on (enables them) and a passcode will be required to enter the programming
interface the next time you try to access it.
The passcodes control who has access to the features of your dome (see Turning on passcodes ). Only the
installer through the installer passcode has permission to turn on, turn off, or change the passcodes. If no
passcodes are programmed, all users are given installer access and are not required to log on. If only the Admin
and Operator passcodes are programmed, then anyone can still access the entire programming interface as an
installer, since the Installer passcode was not programmed.
Turning on passcodes
You can turn on one installer passcode, one admin passcode, and one operator passcode. They have the
following permissions:
Installer: The installer passcode allows access to all dome features.
Admin: The admin passcode allows access to all dome features, except passcodes and firmware
upgrades.
Operator: The operator passcode allows no access until it is granted access to specific features on an
area-by-area basis.
To access the programming interface and turn on passcodes, do the following:
CAUTION: If you use passcodes, record them in a secure place. If you forget the passcodes for a dome, you will need to
send the dome back to the factory so that it can be reset by the factory with no passcodes.
1. At the normal display, press and hold the set
( ) key on the keypad until you hear a beep
and the programming code display appears
on the keypad’s LCD.
Figure 21. Normal display (programming interface accessed)
2. At the ENTER PROGRAMMING CODE
display, enter the programming access code
by pressing the
9 , 5 , 1 , and seq keys.
This code is the same for all GE keypads.
Figure 22. ENTER PROGRAMMING CODE display
CAMERA 1
MONITOR 1
ENTER PROGRAMMING
CODE: _