CamPlus 2 Vandal Resistant Dome IP Camera
Installation Manual
14
Follow these guidelines when installing your camera:
•
When wiring the cable by exposed wiring, be sure to use a sleeve to prevent the cable from being
exposed to the direct sunlight. Connect the cable using a surface box (
Figure 13
).
Figure 13. Cable connections using a surface box
•
Install the camera so that the cable is at the bottom side of the camera. Draw out the cable to the side of
the mounting fixture (
Figure 14
).
Figure 14. Bottom side of camera facing down
•
When installing the camera on a wall, install it so that the water drain groove is facing down
(
Figure 15
). Do not block the water drain groove. Blocking the water drain groove will prevent the
dehumidifying element at the rear of the camera from functioning. Water that builds up inside the
mounting fixture also blocks the dehumidifying element and this will cause malfunction.
Figure 15. Installing on a wall
Surface box
Bottom side
Water drain
groove
Sleeve
