GE Interlogix KTD-405, User Manual, Page: 19 / 60

KTD-405/405A User Manual Programming
1036547C / December 2003 19
Note:
Pressing
!
forwards you through programming without changing set parameters.
RESET TO DEFAULTS? NO
(+)=YES (-)=NO
"
NEXT
!
+ 1 = RESET ALL BUT TITLES
2 = RESET ALL 3 = CAMERA
–
!
If
1
pressed.
PARTIAL. ARE YOU SURE?
(+)=YES (-)=NO
"
NEXT
!
If
2
pressed.
COMPLETE. ARE YOU SURE?
(+)=YES (-)=NO
"
NEXT
!
If
3
pressed.
RESET CAMERA X ?
ARE YOU SURE? +,YES -,NO
Note:
Only CyberScout cameras are reset (i.e.,
reinitialized) when
3
is selected. CyberDomes are reset
from the CyberDome programming menus. Refer to the
CyberDome Programming Manual
.
KEYPAD ADDRESS: 99
(01-99)
"
NEXT
!
INITIALIZING DEFAULTS
PLEASE WAIT
A keypad address is a two-digit number (01 – 99) that distinguishes a keypad from other devices. This
address is automatically assigned when the keypad is first connected into the RS485 communication line.
The address doesn’t change unless you assign a new address or the system configuration changes.
Note:
Entering an address that is already assigned displays a menu that reads ADDRESS ALREADY IN USE.
Entering a keypad address or pressing
!
displays the following menu:
KB3 PTZ PROTOCOL? NO
(+)=YES (-)=NO
"
NEXT
!
If the KTD-405 is being used in a system that needs to communicate PTZ commands to a Calibur
CBR-KB3/J keypad or ProBridge, you must select
YES
so that the KTD-405 communicates properly with
these devices.
ENABLE REMOTE PRGMG? YES
(+)=YES (-)=NO
"
NEXT
!
Enabling remote programming allows the keypad’s user to enter the
9
-
5
-
1
-
seq
code for programming
remote devices in the system. If disabled, a tone sounds when the
9
-
5
-
1
-
seq
code is entered.