0150-0178F
17
Kalatel DVSe
Disks with a
T
status may be recovered, but the DVSe will
attempt to start recording to this disk. A recovery should not be
attempted until the preceding disk is filled up. Contact Technical
Support for detailed instructions on replacing or recovering
problem hard disks.
Be sure to confirm that the drives are connected according to the
diagram in Section 2.3 before removing or replacing. The disk
status display and LEDs represent the wiring and Master/Slave
configuration, not the physical location of the drives.
Reset Disk Failure
This command allows the DVSe to re-enable
disks with timeout errors and reset the Disk
Status. Changing this setting restart the unit.
Any time that a disk is replaced, added, or
removed this command must be executed.
3.5 Upgrading the DVSe
Upgrading the software for the DVSe is accomplished via the ethernet port
and a PC/Laptop equipped with a web browser.
To properly upgrade the Kalatel DVSe the following preconditions must exist:
1.
The Flash upgrade file and path. This file is obtained by calling Kalatel
Technical Support at 1-800-469-1676. When calling, please have the
following information available:
q
The model number of the product.
q
The serial number and revision of the product
q
The current firmware version.
q
The date purchased.
q
Symptoms of the unit that might require upgrade.
2.
The DVSe unit connected to a PC equipped with Microsoft Internet
Explorer version 5.5 or later via ethernet cable.
3.
The IP address of the DVSe.
4.
WaveReader software must NOT be connected to the DVSe. Please
exit all non-essential software on the PC.
NOTE
NOTE
