0150-0178F
13
Kalatel DVSe
3 DVSe Setup
This section contains important information on setting up the DVSe for
operation. Please read the entire section before performing any work.
3.1 Connecting by SCSI or 1394
Caution!
The DVSe does NOT support the simultaneous use
of the SCSI and 1394 ports. Only connect one type of device at
a time.
SCSI
Connect a SCSI device to one of the two SCSI ports using the supplied SCSI
cable. Set the dip switches (SW1) on the back panel. Set
SCSI Termination
and
SCSI Power
to
On
. Select
SCSI
as the type of Bus in the
Setup Menu
under
Bus Select
.
Caution!
Power must be shut down before connecting SCSI
cables between SCSI devices and the DVSe.
Dip Switches (SW1)
Set the Dip Switches to enable or
disable the features listed on the
illustration to the right. Switch
position up to turn off (disable), down
to turn on (enable).
OFF
1 2 3 4
ON
1: SCSI TERMINATION
2: SCSI POWER
3: BUZZER
4: AUX
1394 Firewire
Connect a 1394 device to one of the two 1394 ports using the supplied 1394
cable. Set the dip switches (SW1) on the back panel. Set
SCSI Termination
and
SCSI Power
to
OFF
. Select
1394
as the type of Bus in the
Setup Menu
under
Bus Select
.
Caution!
Power must be shut down to all devices before
connecting 1394 cables between the 1394 device and the
DVSe.
