Connecting to recorder (if used)
Action
Step
Connect the recorder to the Analogue out socket using the cable supplied.
Each wavelength signal is available on a separate channel using the following
wires:
1
+
Wire 1
λ1
-
Wire 2
+
Wire 3
λ2
-
Wire 4
+
Wire 5
λ3
-
Wire 6
Note:
The signal cable is delivered with protective covers on each wire. Do not re-
move the protective covers from unused connections as a short circuit may
disturb the measurements.
Set the recorder to 0 to 1 V input, full scale, 0 V offset.
2
Connecting to auxiliary
equipment (if used)
NOTICE
Any computer used with the equipment shall comply with IEC 60950
and be installed and used according to the manufacturer's instruc-
tions.
Connect any auxiliary equipment to the Remote socket, 9-pole D–Sub female (5 V TTL
signals only).
38
Monitor UV-900 Operating Instructions 28962214 AD
4 Installation
4.5 Connecting electrical cables
