MDS 05-6399A01, Rev. F
MDS™ Master Station
63
Perform Failover
If the Master Station is equipped with redundant SD radios, the active radio can be manually
toggled by selecting the “Perform action” button.
The manual toggle-switch on the alarm/relay board must be in the ‘Automatic’ position
for this operation to succeed. The toggle-switch will override all software-based control
of which radio is active.
Remote Management Command
The Master Station has the ability to broadcast management commands to remote SD radios in
the network. These commands are sent to all connected remote radios, and hence should only be
used for making network-wide changes.
The following action can be specified:
•
Reboot
– All remote radios will reboot to the currently active firmware image.
•
Set Radio Mode
– Change the radio mode of remote radios (x710/transparent/packet-
with-MAC)
•
Set Frequencies
– Set the receive and transmit frequencies of remote radios.
•
Set Modem Type
– Change the configured modem of remote radios.
•
Set Transmit Tolerance
– Change the configured transmit tolerance of remote radios.
•
Set System ID
– Change the configured system ID of the remote radios.
•
Enable Bridge
– Enable or disable Ethernet bridging on remote radios.
•
Enable Encryption
– Enable or disable OTA encryption on remote radios.
•
Set Payload Encryption Phrase
– Change the payload encryption phrase on remote
radios.
•
Set Dlink Encryption Phrase
– Change the Dlink encryption phrase on remote radios.
(Only used in transparent mode)
•
Set SCD
– Change the Soft Carrier Dekey value on the remote radios.
