6
MDS™ Master Station
MDS 05-6399A01, Rev. F
6.
The AC socket outlet shall be installed near the equipment and shall
be easily accessible.
7.
The power supply cord must be disconnected from the appliance inlet
before removing any power supply from the chassis.
8.
CAUTION: THIS UNIT HAS MORE THAN ONE POWER SUPPLY
CORD. DISCONNECT THE TWO POWER SUPPLY CORDS
BEFORE SERVICING TO AVOID ELECTRIC SHOCK
9.
The equipment chassis shall be permanently grounded though a size
six screw and a star toothed washer.
10.
The interior of the equipment is not for operator access.
FCC Part 15 Notice
This Equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case users will be required to correct the interference at their own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received; including interference that may cause undesired operation.
Warning:
Changes or modifications not expressly approved by the manufacturer could void the
user’s authority to operate the equipment
FCC IDs of Available Transmitters
As of the printing date, the following identifiers are assigned to the modules listed below. For the
latest, official listings of all agency approvals, please contact your factory representative.
Radio Desc.
FCC ID
IC ID
WIFI Module
M4Y-ZCN722MV1
3195A-ZCN722MV1
LN 400Mhz Module
E5MDS-LN400
101D-LN400
LN 700Mhz Module
E5MDS-LN700
n/a
LN 900Mhz Module
E5MDS-LN900
101D-LN900
SD 400Mhz Module
E5MDS-SDM4
101D-SDM4
SD 900Mhz Module
E5MDS-SDM9
101D-SDM9
Canada, IC ERP Limits
IC SRSP-501, 6.3.2. Limits the ERP to 125W for fixed point-to-point operation. For IC use, the
antenna gain and Transmit power must be set to meet the ERP limit of 125W. This can be
accomplished by using the appropriate at antenna gain in combination with the RF power
settings