Page
18
of 37
HES7000 ICL
I User’s Guide A01583 Rev. A
Example 3. Changing Between ICLI Modes
Initial mode for this example is Unprivileged Exec.
Raise level (and change mode):
myDevice>
enable Password
:
***
myDevice#
Note how the prompt changed from ‘>’ to ‘#’ to indicate the privileged exec mode
Enter Global Configuration mode:
myDevice#
configure terminal
Now create VLAN 100 and give it a name. This enters the VLAN sub-mode,
as indicated by a new prompt:
myDevice(config)#
vlan 100
myDevice(config-vlan)#
name MyVlan
Change directly from VLAN sub-mode into Ethernet interface sub-mode for
interface instance 4 on switch 1, and set link speed to ‘auto’
myDevice(config-vlan)#
interface GigabitEthernet 1/4
myDevice(config-if)#
speed auto
Then enter a command from the global configuration mode; this exits Ethernet interface sub-
mode
myDevice(config-if)#
hostname myDevice
Exit Global Configuration mode and go back to Privileged Exec
myDevice(config)#
end
And use ‘disable’ to go back to Unprivileged Exec:
myDevice#
disable
myDevice>
Summary of Contents for HES7000
Page 1: ...HES7000 ICLI USER S GUIDE A01583 Rev A ...
Page 3: ...HES7000 ICLI User s Guide A01583 Rev A ...
Page 4: ......
