- 53 -
December 22
nd
, 2022
GDC SR-1000 STANDALONE INTEGRATED MEDIA BLOCK
™
INSTALLATION MANUAL
16. SR-1000 INPUT AND OUTPUT
4
Connection to D-Box
AES output 13
on the SR-1000 carries the Motion Data
signal used by D-Box (assuming DCPs follow the
16 channels ISDCF recommended channel order).
The
AES pair 13/14
is available on the
RJ45 Connector
labeled
A-bot
on the IMB and can be connected to the
D-Box system.
Appropriate cable and connectors should be chosen
keeping in mind the connector used on the
D-Box system.
5
Connecting a Microphone
*
A Microphone can be connected to the
MIC. IN
on the
front panel of the AIB-2000 using a
Male XLR
Connector
.
If the microphone requires Phantom power, then press
the
+48V
button.
6
Connecting a Non-Sync source
*
A Non-sync source can be connected to the
NON-SYNC
IN
on the front panel of the AIB-2000 using Male XLR
connectors or to the
NonSync IN
on the back panel
using Male stereo
RCA Connectors
.
NON-SYNC
front/back button switches Non-Sync input
between front
XLR
and rear
RCA Connectors
.
7
Connecting an HDMI source
An HDMI source can be connected to the
HDMI IN
on
the faceplate of the SR-1000, using an HDMI cable.
8
Connecting a Booth Monitor
*
AES pair 9/10
on the SR-1000 carries a mix of L+C+R
which can be used as a monitor output.
The
AES pair 9/10
is available on the
RJ45 Connector
labeled
A-bot
on the IMB and can be connected to the
Booth monitor via a
D/A
Converter.
Table 5
* Refer to the
‘AIB
-
2000 User Manual’
for more details.
IMPORTANT
: Please check and set the levels of the analog input sources to the AIB-
2000 appropriately, to avoid any damage to the auditorium speakers.
