DU-AG-0018-25 Rev J 4/19/17 GCX Corp Page 3 of 8
M6 x 14 mm PHMS (2)
Mounting Plate
Spacer
M6 x 12mm FHMS (3)
2.
While supporting the bottom of the Arm, guide the Slide into the top of the channel (below left) and move Arm to
required mounting position.
3.
Using the 1/8'' hex wrench provided, tighten four (4) set screws in Slide to secure position of Arm (below right).
Mounting the Monitor on the Arm
Table Mount
Mount the monitor in accordance with the Philips Table Mount instruction sheet.
CAUTION
: Ensure the device mounting locking mechanism is properly engaged at all times
Fixed Mount
1.
Fasten Spacer to Mounting Adapter with three (3) M6 x 12mm FHMS (left).
2.
Pre-set two (2) M6 x 16mm PHMS through bottom of Mounting Plate and thread into placement holes in the Spacer
(middle).
3.
Align the mounting holes in bottom of monitor with the pre-installed M6 x 16mm PHMS and thread (right).
Installation Note:
Counterbalance Adjustment must be performed after monitor and FMS are mounted on the Arm.
Insert Slide
Set Screws (2 lower)
Set Screws (2 upper)