DU-AG-0018-25 Rev J 4/19/17 GCX Corp Page 2 of 8
Height Locking Lever
M6 X 12mm FHMS (3)
Mounting Plate
Table Mount
*Supplied by Philips
Warning!
Do not stack the Table Mount and Spacer when
installing the Table Mount.
3.
The combination of MP60/70 and an 8-slot or 4-slot FMS exceeds the acceptable load limit for the VHM Arm.
MP60/70 can only be used without a FMS.
4.
If assistance is needed regarding an application, please contact a GCX product specialist at (800) 228-2555 or +1 707-
773-1100.
Attaching the Philips-supplied Table Mount to the Mounting Adapter
1.
Fasten Philips-supplied Table Mount to Mounting Adapter with three (3) M6 x 12mm FHMS (see below).
Mounting VHM Arm in Channel
1.
Thread the Height Locking Lever into the mounting hole in the right side
of the Arm. The Lever operates by turning clockwise to tighten or
counterclockwise to loosen. Ensure that the Locking Lever is in the
locked position before mounting the Arm in the channel.
Do not attach Table Mount if monitor
has this mounting interface.
Attaching the Philips-supplied Table Mount to the Mounting Plate
Installation Note: Do not attach the Table Mount to the Arm/Mounting Adapter if
you will be mounting a monitor with the mounting interface shown in photo (right).
See "Mounting the Monitor" (page 3) for instructions specific to this type of
mounting interface.