Page 3
BEFORE INSTALLING
Check contents for any sign of damage. If the VAV assembly is damaged in any way, contact the dealer or seller
immediately.
The BASYX VAV comes ready to mount directly onto the damper shaft using the attached V-Clamp. The VAV
electronics board is housed within the clamshell type enclosure and the entire assembly is attached to the duct with
one sheet metal screw.
If using the BASYX VVR board with a motor other than a BELIMO, contact your GCS dealer to verify compatibility and
power requirements.
Figure 1: BASYX VAV controller assembly
Figure 2: BASYX VVR retrofit controller
The VAV controller assembly is designed for use on new construction projects or retrofit of existing variable air
volume terminals where actuators are replaced, i.e. pneumatic conversion, etc. The controller is a self-contained unit
which consists of a plastic enclosure and 3-wire floating damper actuator.
The VVR retrofit controller is used on existing variable air volume terminals where existing 3-wire floating actuators
may be reused. The unit is a snap-track mounted unit, and may be installed in existing VAV unit control enclosures.
Figure 1 shows the VAV controller assembly and Figure 2 shows the VVR retrofit controller.
Contact Global Control Solutions or your local dealer/distributor if unsure about the compatibility of any existing
actuator or box type.
