Bengal User Manual
Trouble Shooting
5-3
Warning 4
Cannot repeat cutting
There are two possibilities:
1. There is no data in the buffer: please send the job again from your computer;
2. The buffer is full: please send the same job from your computer again.
Under both conditions, press the ON/OFF LINE key to clear the warning message.
Warning 5
Communication error
Check that the serial/USB/parallel cable has been connected to the cutting plotter and
computer properly.
If so, then check whether the interface settings are correct. Check that the communication
settings in your PC are the same as the ones on your cutting plotter (for example – 9600bps,
no parity, 8 bits, 1 stop bit). Then, press ON/OFF Line key to switch back to On Line mode.
Warning 6
Width sensor error
Check that the pinch rollers are positioned above the grid drum and reload the media again.
In order to identify the warning messages easily, please stick the warning
sticker (in accessory box) on the side cover of your cutting plotter.
Note:
5.2.2 Error Indicators
If some mechanical problems occur during the operation, the ERROR LED will turn on. Please
follow the instructions below to solve the problem. If the cutting plotter still cannot work,
please contact your local dealer and tell him or her about the error indicator.
Error
Indicators
ERROR
ON/OFF
LINE
REPEAT
DATA
CLEAR
CUT
TEST
1 SRAM
error
2 DRAM
error
3
Check media, drum, or X motor
4
Check media or Y motor
= flash
= on
= off
Error 1 and 2
Please contact your local dealer to replace SRAM or DRAM.
