Bengal User Manual
Installation 2-8
9
DO NOT move the pinch roller by holding its front rubber roller (Figure 2-16).
9
Move the pinch rollers by applying force at the rear portion of the pinch roller support.
Note:
9
Always adjust the position with the pinch rollers raised.
(X)
Incorrect
Figure 2-16
2.4.2
Loading the Roll Media
You can either use the stand with flexible media support system or desktop media support
system for roll media. Please refer to Chapter 2.2 for hardware setup, and Chapter 2.4.1 for
media loading.
2.5 Cable Connection
The cutting plotter communicates with a computer through a
USB (Universal Serial Bus), Parallel
port
(Centronics), or
a
Serial port
(RS-232C)
. This chapter shows you how to connect the cutting
plotter to a host computer and how to set up the computer/cutting plotter interconnection.
!!
Notice:
When USB connection is enabled, serial port will be disabled automatically.
Figure 2-17
Parallel port
Serial port
USB port
