1. Installation
*NOTE: It may be more convenient to perform the initial
configuration of the IP Doorbell with it temporarily connected to
power nearby your home internet router and a computer. This
way testing and operation can be verified before the unit is
mounted permanently.
-
Location:
Choose a location for your new IP Doorbell, taking into
consideration sightlines, shadows, and excessive back - ground
lighting for the camera. You must also consider proximity to AC
power and the ability to run wiring for additional
optional
accessories. Optimal mounting height would be approximately
60
”
(150cm) up from the surface that the caller is standing on.
Consider drilling a 1
¼”
diameter or larger hole into the wall
behind the IP Doorbell to allow for the concealment of the Wi-Fi
antenna (if used) within the wall.
-
Back Box Mounting:
Feed the power supply wiring, wiring
harness(s), and the Wi-Fi Antenna cable or the RJ-45 cable
through the hole from the back side of the back box. Use the
four screws (and anchors, if required) supplied to mount the
back box to the wall in the desired location.
-Set the desired unlock duration time using the switch on the
back of the IP Doorbell, and then connect the wiring harness and
other connections to the back of the IP Doorbell. Gently feed
excess wiring through the hole in the back box into the wall
cavity, and place the IP Doorbell into the back box (top first).
*NOTE: The RJ45 jack is not wired for POE. See appendix A.
-Secure the IP Doorbell into the back box at the bottom
leading edge using the two supplied Hex-Head screws and
Allen key.
- 6 -
