5. Keypad Programming
(PL960QPM/TPM)
The PL960QPM/TPM keypad can be custom programmed with up to 40
different access codes, and will trigger the same relay that is triggered
through the ControlCam2 App. The length of the access codes and
programming password can be programmed to be two to six digits in length
(globally).
However, the master password and unlock delay times set in the keypad
are independent of the IP Doorbell. A factory reset of the IP Doorbell will
not affect the programming contained in the keypad and vice versa. The
keypad requires a separate factory reset to clear
it’s
programming.
5.1 Modify the Programming Password:
1.Disconnect power to the IP Doorbell.
2. Restore the power to the IP Doorbell. Two short chirps will be heard.
3.
Within 3 seconds press the ’ ’ button
once.
4. Enter the new password (length determined through other
programming). A longer beep is heard, indicating the new password has
been successfully stored.
5. Press
’ ’ to exit the programming mode.
5.2 Enter Programming Mode:
1.
Press the ‘ ’ button, a chirp is heard.
2. Enter the programming password (default is 1234). A longer beep is
heard, indicating the IP Doorbell is now in programming mode.
3. The IP Doorbell will automatically exit programming mode if there is no
input at the keypad for over 30 seconds or press ‘*' to exit programming.
5.3 Set Unlock Duration Time:
1. Enter programming mode.
2.
Press ‘00’, a longer beep is heard.
3. Enter two digits (01
–
99) representing the new unlock duration time,
in seconds. A longer beep is heard confirming the change.
4.
Press ‘ ’ to exit the programming mode.
*
*
*
*
- 23 -
