![background image](http://html1.mh-extra.com/html/gbc/orca-1600/orca-1600_operation-and-maintenance-manual_571022093.webp)
Page 8 - 4
Maintenance
Orca 1600 Operation and Maintenance Manual
© GBC Films Group February 2001
d) Set a slow speed of less than 3 ft/ min. ( 91 cm/
min. ).
e) Put on the rubber gloves and use the isopropyl
alcohol and terry cloth towel to rub where the
dirt is on the rollers.
C A U T IO N
E xcessive pressure can d estroy th e silicone
layer by pressing to hard or scrub bing
too long in one spot.
K eep the terry cloth tow el kind of dam p to
m ake the rubb ing of the roller sm ooth.
IN F O R M A T IO N
f) Use the footswitch to rotate the roller to a new
spot to clean.
g) Do this as many times as needed to clean the
laminator rolls.
8.5 Thermal adhesive
a) Allow the laminator to cool slightly, no higher
than 110
o
F ( 43
o
C ).
C A L 32 00
< 1 1 0
C A L 32 00
< 1 1 0
C L E A N IN G H E A T E D R O L L E R S C A N
IG N IT E T H E FU M E S!
C A U T IO N
b) Set the machine direction to FWD when cleaning
the pull rollers. Set the machine direction to REV
when cleaning the main rollers.
( if cleaning
pull rollers )
( if cleaning
m ain rollers )
FW D
R E V
FW D
R E V
O R
c) Remove the front table and table idler to gain more
access to the main rollers or remove the rear table
to gain more access to the pull rollers.