Operations
Page 5 - 3
Orca 1600 Operation and Maintenance Manual
© GBC Films Group February 2001
( 6 ) Temperature Control Unit ( Bottom ): This
unit is used to set the desired heating temperature of
the bottom main roller. The display can be programmed
to show
o
F or
o
C.
C A L 3 2 0 0
6 8
C A L 3 2 0 0
6 8
( 7 ) Top Heater on / off Switch: Turns the
temperature controller unit for the upper main roll to
on ( I ) or off ( O ).
T op tem peratu re control unit on/ off
sw itch m ust be on to turn the low er
tem p erature control unit to on.
IN F O R M A T IO N
( 8 ) Bottom Heater on / off Switch: Turns the
temperature controller unit for the lower main roll to
on ( I ) or off ( O ).
H E A T
T O P
B O T T O M
( 9 ) Main Roll Pressure Adjustment: Adjusts the
air pressure supplied to the main roller air cylinders.
Pull out on the knob to turn and push in on the knob
to lock down.
W hen decreasing pressu re, allow the
pressure guage to drop b elow the desired
value, then increase pressure to th e set
pressure desired. T his allow s for a m ore
accurate pressure readin g.
IN F O R M A T IO N
( 10 ) Main Roll Pressure Gauge: Displays the air
pressure supplied to the main roller air cylinders.
( 11 ) Main Roll up / down Switch: When pressed to
the down position, the upper main roller lowers. When
pressed to the up position, the upper main roller raises.
P R E S S U R E
R O LL
A D J
10
20
30
40
50
60
70
80
90
100
0
P .S .I.
( 12 ) Main Power Indicator Light: When
illuminated, there is electrical power going to the
machine.