Operations
Page 5 - 12
Orca 1600 Operation and Maintenance Manual
© GBC Films Group February 2001
5.8 Pull roller nip
To set the pull roller nip for use with substrates
can easily be obtained by setting the shim dials on the
pull roller to the desired opening.
a) Ensure the upper pull roller is in the up
position.
T he n ip can on ly be changed w ith the
upper roller in the up position.
IN F O R M A T IO N
b) Turn the shim dial to the desired setting.
R e a r o p e ra tin g p o s itio n
S h im d is k s
( v ie w e d fro m th e to p o f la m in a to r )
c) Adjust pull roller pressure for the desired
setting with respect to the substrate being used.
d) Press the pull roller UP/ DOWN switch to
DOWN on the rear control panel.
5.9 Shutdown procedure
Perform the steps below to properly shutdown
your machine.
a) Unweb the laminator and clean the rollers as
described in Section 8.2 Cleaning the rollers.
b) Set the left and right shim dials of the main
roller to greater than 1/2 inch ( 1.27 cm ).
T his w ill prevent the m ain rollers from
contacting if th e air shou ld be rem oved.
IN F O R M A T IO N
c) Set the pull roller shim disk to 1/2 inch.
T his w ill prevent the pu ll rollers from
contacting if th e air shou ld be rem oved.
IN F O R M A T IO N
d) Turn the power ON/ OFF switch on the
laminator to OFF.
