28
— choose the mode of air distribution by turning handle
1
;
— turn handle
2
to get the desirable rate of the air flow coming to the pas
senger compartment;
— adjust the direction of air flows by turning the shutters of ventilation
grids.
To make heating and ventilation effective be sure that the grid of the hole
for air intake located on the hood before the windscreen is free from leaves,
snow, etc.
8.5. LIGHTING AND LIGHT SIGNALING DEVICES
Caution!
Headlampblock with marking ОАО "ОСВАР" lenses are made of
plastic material. That is why
never
use fuels and other aggressive fluids, as well
as dry brushes and wiping waste for cleaning from dust and dirt.
Remove the dirt from these parts with water jet only.
Headlamps
. To replace dipped beam and clearance lamp bulbs it is neces
sary to remove rubber cover
3
(Fig 8.4).
To replace main beam bulb remove rubber covers
3
and
5
, and unscrew
connector
1
to replace turn indicator bulb.
Knob
2
is designed to adjust the direction of light beam in horizontal plane.
Vertical adjustment of the light beam is carried out through opening
4
using
hexagon spanner or crosshead screwdriver.
Fig. 8.4.
Headlampblock
1 — connector; 2 — light beam horizontal adjust
ment knob; 3 and 5 — rubber covers; 4 — opening
for light beam vertical adjustment
Additional vertical adjustment of the dipped beam depending on vehicle
loading is performed from the cabin by means of the headlamp aiming device
control unit handwheel.
On an unladen vehicle it is necessary to make "0" on the handwheel coin
cident with "•" mark on the control unit housing.
On a fully laden vehicle it is necessary to make "4" on the handwheel coin
cident with "•" mark on the control unit housing.
