7
Pro
line
Pro
line
7.6
Connecting up to 500 or 1000 luminaires
Using a setup with daisy chained splitters, up to 500 luminaires on RS1 or EL1 and 1000 luminaires on EL2 (over two
channels) can be connected as shown in fig. 14.
1. Use the black controller cable (item comes with the controller) to connect the primary channel of the controller to the
input port of the first splitter (14A).
2. Remove the dummy from the input port of the luminaires (11).
2
Note:
Keep the dummy in a safe place! The dummy is necessary to operate the luminaire in standalone mode.
3. Use a grey 6PC6 modular jack interconnect cable (item C.) to connect the output port of the splitter to the input port of
the first luminaire (14C).
4. Use a grey 6PC6 modular jack interconnect cable (item C.) to connect the output port of the first luminaire to the input
port of the second (14D).
5. Repeat these steps to connect up to 100 luminaires per splitter output port (14E). Up to 500 luminaires can be
connected to the primary channel.
6. Snap-on two grey ferrite cores (item D.) on the grey interconnect cable (item C.) close to the 6P6C plugs.
7. Use the grey 6PC6 modular jack interconnect cables (item C.) to connect the outport of a splitter to the inport of the
next (14B).
8. Use the black secondary channel (item comes with controller) (14G) to connect another 500 luminaires, in the same
way the luminaires are connected to the primary channel.
6
Warning!
Ensure the power cord and the controller cables do not touch any of the reflectors.
6
Warning!
Distribute number of luminaires evenly over daisy chains.
6
Warning!
Ensure the repeater bus connections are integrated in a correctly set up installation for best results.
6
Warning!
Boosters should never be used to expand.
6
Warning!
The maximum cable length per splitter is 250m (100 interconnect cables).
1
2
100
C
D
E
101
102
200
201
202
300
401
402
500
F
301
302
400
501 - 1000
B
A
G
14
