Protecting from power source problems
www.gateway.com
13
Uninterruptible power supplies
Use an uninterruptible power supply (UPS) to protect your server from data loss
during a total power failure. A UPS uses a battery to keep your server running
temporarily during a power failure and lets you save your work and shut down
your server. You cannot run your server for an extended period of time while
using only the UPS. To buy a UPS, visit
accessories.gateway.com
.
Removing and installing the bezel
To remove and install the bezel:
1
Follow the instructions in
“Preventing static electricity discharge” on
. Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
2
If the server is mounted in a cabinet, remove the server from the cabinet.
For instructions, see the instructions that accompanied the rail kit.
3
If the bezel door is installed, unlock (if necessary) and open it.
4
Open the server case by following the instructions in
5
Close the bezel door, then pull out on the three retaining tabs on the left
side of the bezel to disengage the tabs from the chassis.
Retaining tab
Retaining tab
Retaining tab
Summary of Contents for E-9520T
