Gateway E-9520T, User Manual

Page: 35 / 126

Opening the server case www.gateway.com
29
Caution
ESD can permanently damage
electrostatic discharge-sensitive
components in the server. Prevent ESD
damage by following ESD guidelines
every time you open the server case.
■
Avoid working on the server when your work area is extremely humid.
■
Remove components from their antistatic bags only when you are ready
to use them. Do not lay components on the outside of antistatic bags
because only the inside of the bags provide electrostatic protection.
■
Always hold expansion cards by their edges or their metal mounting
brackets. Avoid touching the edge connectors and components on the
cards. Never slide expansion cards or components over any surface.
Opening the server case
Caution
For correct cooling and air flow, always
reinstall the cover before you turn on the
server. Operating the server without the
cover in place will cause the server to
overheat.
Because the components inside your server are extremely sensitive to static
electricity, make sure that you follow the instructions at the beginning of this
chapter to avoid static electricity damage.
To open the server:
Warning
This server may have two power cords. To
disconnect internal AC power, you must
unplug both power cords.
1
Follow the instructions in “Preventing static electricity discharge” on
page 28 . Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
2
If the bezel is installed, unlock and open it.
3
If the server is mounted in a cabinet, remove the server from the cabinet.
For instructions, see the instructions that accompanied the rail kit.
4
Place the server on a stable, non-skid surface.
5
Unlock the case cover lock on the front panel of the case.
Case cover lock