Gateway 210, User Manual

Page: 52 / 58

48
Appendix : Safety, Regulatory, and Legal Information
www.gateway.com
Setting up the projector
■ Read and follow all instructions marked on the product and in the documentation before you
operate the projector. Retain all safety and operating instructions for future use.
■ Do not use this product near water or a heat source such as a radiator.
■ Set up the projector on a stable work surface.
■ The product should be operated only from the type of power source indicated on the rating label.
■ If the projector is connected to a computer, make sure that the voltage selector switch is in the
proper position for your area. The voltage selector switch is set at the factory to the correct
voltage.
■ Openings in the projector case are provided for ventilation. Do not block or cover these
openings. Make sure you provide adequate space, at least 6 inches (15 cm), around the projector
for ventilation when you set up your work area. Never insert objects of any kind into the
ventilation openings.
■ Some products are equipped with a three-wire power cord to make sure that the product is
properly grounded when in use. The plug on this cord will fit only into a grounding-type outlet.
This is a safety feature. If you are unable to insert the plug into an outlet, contact an electrician
to install the appropriate outlet.
■ If you use an extension cord with this projector, make sure that the total ampere rating on the
products plugged into the extension cord does not exceed the extension cord ampere rating.
■ If the projector is connected to a product fitted with a TV Tuner, cable, or satellite receiver card,
make sure that the antenna or cable system is electrically grounded to provide some protection
against voltage surges and buildup of static charges.
Care during use
■ Do not walk on the power cord or allow anything to rest on it.
■ Do not spill anything on the projector. The best way to avoid spills is to avoid eating and
drinking near the projector.
■ When the projector is turned off, a small amount of electrical current still flows through the
projector. To avoid electrical shock, always unplug all power cables from the wall outlets and any
other cable connections before cleaning the projector.
■ Unplug the projector from the wall outlet and refer servicing to qualified personnel if:
■ The power cord or plug is damaged.
■ Liquid has been spilled into the projector.
■ The projector does not operate properly when the operating instructions are followed.
■ The projector was dropped or the projector case is damaged.
■ The projector performance changes.
Replacement parts and accessories
Use only replacement parts and accessories recommended by Gateway.
Important Do not use Gateway products in areas classified as
hazardous locations. Such areas include patient care
areas of medical and dental facilities, oxygen-laden
environments, or industrial facilities.