GatesAir Intraplex T1 DCS-9530 CrossConnect System, Installation And Operation Manual, Page: 87 / 106

T1 CrossConnect Installation & Operation Manual 6 – Configuration Using ISiCL
Version 2
6-6 GatesAir
Intraplex Products
Note that the
*OK
in the first line of the response indicates that the received command was valid, not
that the DCS is “okay.”
6.10 DCS SET Parameters
6.10.1 DCS SET Command Use
The setup of a DCS chassis can be changed by issuing
SET
commands with the appropriate parameter
names and values. The key is to include the
DCS
value in the subaddress field of the command line.
For example, to set the recovery time to 0.1 second of a DCS connected to a multiplexer at address
32, issue this command:
32:DCS:SET:REC=0.10;
Table 6-2 lists the valid DCS:SET: parameters that can be changed remotely.
Note: CrossConnect products shipped before November 1, 1999 only respond to the command
:DACS:SET:
while products shipped after that date respond to either
:DCS:SET:
or
:DACS:SET:
commands.
Table 6-2. Valid
:DCS:SET:
Parameters and Legal Values
Parameter Function Legal Value Sets Parameter To
ACT1 Port 1 active/
not active
ON Port 1 in service
OFF Port 1 not in service
ACT2 Port 2 active/
not active
ON Port 2 in service
OFF Port 2 not in service
ACT3 Port 3 active/
not active
ON Port 3 in service
OFF Port 3 not in service
ACT4 Port 4 active/
not active
ON Port 4 in service
OFF Port 4 not in service
ACT5 Port 5 active/
not active
ON Port 5 in service
OFF Port 5 not in service
ACT6 Port 6 active/
not active
ON Port 6 in service
OFF Port 6 not in service
ADDR Shelf address 1 – 63 Sets CM-95 shelf address
BER Bit error rate 10
-6
to 10
-3
Bit error rate
CLOCK Clock source Alt1, Alt2 Alt1 = Alternate Clock 1 (I (Internal), E (External), 1-6)
Alt2 = Alternate Clock 2 (1 to 6) (optional)
CODE, P T1 line code AMI Alternate Mark Inversion
P – port number (1 to
6)
B8ZS High Density Bipolar
DLY1 Delay 0 to 100 (ms) Switch time delay, port 1
DLY2 Delay 0 to 100 (ms) Switch time delay, port 2
DLY3 Delay 0 to 100 (ms) Switch time delay, port 3
DLY4 Delay 0 to 100 (ms) Switch time delay, port 4
DLY5 Delay 0 to 100 (ms) Switch time delay, port 5