![background image](http://html1.mh-extra.com/html/gates/z100/z100_setup-use-and-care-manual_3761163033.webp)
Optional External Monitor EM50 or EM43
Page 33
Gates Underwater Products, Inc
13685 Stowe Drive • Poway, CA • 92064 • 858.391.0052 • 800.875.1052 • Fax 858.391.0053
[email protected] • www.GatesHousings.com
The EM43
External
Monitor will
plug into the
camera SD
video output
here.
The EM50
HDMI
connector will
plug into the
camera here.
Camera connection and setup –
Connect to the camera
by plugging in the video cable located inside the housing.
The EM43 video cable will plug into the standard definition composite connector on
the rear of the camera as shown in the image below. The EM50 will plug into the
HMDI connector at the same location.
Verify Operation.
At this time, turn on the camera and if necessary the EM50
monitor, and verify operation.
Set Camera Display.
The camera must be setup to display recording data and
other information on the monitor by setting the following menu selection:
MENU
VIDEO
Output Display
HDMI
ON (for EM50)
MENU
VIDEO
Output Display
VIDEO
ON (for EM43)
Caution
:
If you are not using the EM43 monitor for any reason, do not plug the
RCA connector into the camera.