Camera / Housing setup
Page 13
Gates Underwater Products, Inc
13685 Stowe Drive • Poway, CA • 92064 • 858.391.0052 • 800.875.1052 • Fax 858.391.0053
[email protected] • www.GatesHousings.com
Secure the camera
in the housing by locking the latches. They will have a positive
‘snap’ into position when rotated to the rear of the tray.
Check controls
. With the camera turned on and installed into the housing front,
press in each control and confirm proper operation (refer to the next section for more
detail on controls).
Tip
:
With the camera installed you can now get a good view inside the front
half of the housing and most controls. Use a flashlight if necessary to become
familiar with the operation and ‘feel’ of each control in their proper position prior to
closing the housing.
Slide the camera into the housing.
It should do so without obstruction
and mate with the alignment collar
behind the port opening.
