page 27
of the Control Board, will begin flashing quickly. After about 75 seconds, the gate will
begin moving on its own as it begins learning its travel path.
The learning mode executes as follows:
1.
Master Gate Closes (actuator extends)
2.
Master Gate Opens (actuator retracts)
3.
Master Gate Close (actuator extends)
At this point, you should verify the direction that the gate is opening/closing the gate, as
you want. That the gate is closing in the direction you want it closed (steps 1 and 3
above), and opens in the direction you want it to open.
If the gate does not move in the desired direction, then you will need to reverse the motor
operating direction. To change the operating direction, swap the black and white wires
from J1 Master and J2 Slave.
Two Gate Operation
For a two-gate installation, the first time you click the Remote Control Button 1, the
Control Box will receive the signal and initiate a small red light, located about the middle
of the Control Board, will begin flashing quickly. After about 75 seconds, both gates
begin moving individually as they each learn their travel path.
The learning mode executes as follows (this example is Pull to Open):
1.
Slave Gate Closes (actuator extends)
2.
Master Gate Closes (actuator extends)
3.
Master Gate Opens (actuator retracts)
4.
Slave Gate Opens (actuator retracts)
5.
Slave Gate Closes (actuator extends)
6.
Master Gate Closes (actuator extends)
At this point, verify the direction that the gates open and close is correct and that the
gates are opening and closing in the correct sequence.
If the gates do not move in the desired direction, then you will need to reverse the motor
operating direction. To change the operating direction, swap the black and white wires
from J1 Master and J2 Slave.
Pedestrian Start Feature:
The System can be set to open only one side of the gate for pedestrian traffic:
For a dual gate, connect the motor cables for both terminals J1 & J2. Press the green
button of the transmitter to activate Pedestrian Start.
For a single gate, connect the motor cable for terminal J1 only. Press the black button of
transmitter to activate Pedestrian Start.
