G4-304SD1
User Manual & Install Guide
119 of 149
For all IO lines, set to:
Alarm
Trigger
Click the ( Setup ) button under Trigger to
display the Trigger setup screen for the
associated IO input line.
This will display a drop list which allows you to
select the trigger for this IO input line:
Low (0V)
High (12V – 24V)
DEFAULT SETTINGS:
By default, all the IO line triggers will be set to
High. However, please adjust any or all of these
values as appropriate, as whether the trigger
value is High or Low will depend on the vehicle
and the wiring.
Linkage
Click the ( Setup ) button under Linkage to go
to the Linkage setup screen. This sets up the
video display, recording and snapshot options
associated with this alarm.
The Linkage setup screen enables you to
configure the following options:
Channel – checkboxes which allow you
to select any combination of the
camera channels to be included in the
display and recording.
Post Recording – drop list which
allows you to select the duration for
which video will continue to be
recorded when the alarm is triggered.
Lock – checkbox, if selected will mark
the recorded video associated with this
alarm as locked video.
3G Network – checkbox, if selected
will enable alarm notification over the
3G network.
Linkage IO Output – checkboxes, if
enabled, the device will send a signal
to the selected IO output lines.
Output Delay Time – numeric text
field to set the delay time for the IO
output (in seconds).
