30
SPEED
There are numerous options available for setting within the Speed option. Some of these options are only available
after
other selections have been made. Please Note: An approved GPS antenna is required for the 508-HD to receive satellite signals
for speed.
Once the SPEED menu has been accessed, Speed Source can be selected
as either Vehicle or GPS. If Vehicle is selected please consult the
documentation which came with your vehicle to see how to set up this
connection. Please note: If Vehicle is selected this method is un-supported
by Gatekeeper Systems.
If an approved GPS module has been fitted select GPS as the Speed
Source.
Speed Unit can be set to either MPH or KPH, select the correct Speed
Unit for your location.
To enable Speed check select the Enable menu and set to ON.
Next for either LOWSPEED or OVERSPEED set the THRESHOLD value. Use
the Numeric keypad on the remote control to set the required values.
To have an Alarm be registered when the THRESHOLD value has been
reached or exceeded, set the ALARM option to ON.
Once all selections have been made, highlight the OK button and press
ENTER on the remote control.
Figure 16: Speed.
ACCELERATION
.
If the 508-HD has been fitted with an internal Inertia, G, Sensor this can
be setup with independent values for X, Y and Z axis, these can be set to
the requirements of the individual customer.
The Inertia sensor can be tested by accessing the ACCELERATION
Button, System
Sensor
Acceleration. Once the 508-HD has been
installed click on the Calibrate button (B).
After the Inertia sensor has been Setup ensure it is enabled by selecting
ON from the Drop down menu (A). Once selected press the SAVE button.
Figure 17: Acceleration.
