GPD-100 Instruction Manual
PAGE 15 of 27
Rev 1.1(2019.05.23)
6.
System Mode
6.1.
Mode configuration
Menu structure of the device is as following table.
Item
Display
Description
Note
CONFIGURATION MODE CONF
Configuration
of
internal
function
PROGRAM MODE
PRGM
Configuration of related gas
measurement
CALIBRATION MODE
CALB
Calibration gas
ALARM MODE
ALAM
Configuration of Alarm setting
TIME MODE
TIME
Setting of Internal Time
Factory Mode
SENSOR DATA MODE
S-DT
Check of sensor data
Factory Mode
TEST
TEST MODE Test Mode
Factory Mode
FLOW MODE
FLOW
Configuration of flow setting
Factory Mode
Log Mode
Log
Configuration of log function
MAINTENANCE MODE
M-T
Configuration of Maintenance
setting
Factory Mode
[Table 6. Mode Configuration]
6.2.
Detailed Mode description
Detailed menu and sub-menu of the device is as following table
Level 1
Level 2
Level 3
COnF
Configurat
ion
Add
Specify a detector
number
[01] ranges between 01 and 64
PSWd Set password
[00] ranges between 00 and 99
SUPr
Set the measured gas
suppression rate
OFF 1~50%
PyrO
Set if CEC is used or not
ON / OFF
Py-U
Indicate CEC voltage
1.50U
U-00
Program version number
Prgm
Measurem
ent data
UnIt
Measurement unit
%LEL, %VOL, PPM, PPB
dP-S
Specify location of the
decimal point
Set 0000, 0.000, 00.00 or 000.0
H-SL
Set Full Scale
Set value between 0 and 9999
CALb
Calibration
mode
ZERO ZERO Calibration Mode
YES/no Set ZERO Calibration
0.0
Measured value display
mode
WAIt
Under zero calibration
0.0
Measured value after
completing calibration
