44
the handle. When you have prepared hot dishes, beware of hot steam and condensate,
when opening the lid, to avoid scalds.
11. Holding the glass jar by the handle, lift the glass jar straight upwards and away
from the motor base. Doing so, do not tilt or twist the glass jar on the motor
base.
12. To remove the lid from the glass jar, grasp the handle of the lid with one hand
and the handle of the glass jar with the other hand. Then lift the lid upwards.
Doing so, beware of steam and condensate.
13. Pour out the soup slowly. Empty the glass jar completely and clean the appliance
after use. (See: „Care and Cleaning“)
WARNING! Do not leave the appliance unattended when it is in reach of
young children.
Do not leave any food dry on the surfaces of the appliance. Do not
store food or liquids in the glass jar.
Care and Cleaning
WARNING!
The blades are very sharp. Handle the blades with care.
If the heater function has been used shortly before, the glass jar and especially the bottom
of the jar collar are very hot. Always switch Off the blender function, unplug from power
outlet and allow cooling before disassembling the glass jar, or cleaning the appliance.
Do not immerse the motor base or power cord in water or any other
liquids.
Do not use any abrasive cleaners, cleaning pads, other hard or sharp-edged objects,
chemicals, or corrosive liquids for cleaning as this could affect or damage the surfaces.
Do not spill any liquids on the motor base or the power cord.
Do not place the motor
base in an automatic dishwasher.
Always clean the appliance after each use. Do not leave any food dry up on the appli-
ance or any parts of it to prevent a build up of baked-on foods.
Cleaning the blades
1. Simply add ca. 0.5 Litre of dish-water to the glass jar.
2. Set the timer for 2 minutes and press the Simmer button.
3. When the dish-water is hot, turn the heater off (press Simmer button again), and
switch the Blender control dial to speed selection 1 for ca. 1 minute.
4. Pour out the dish-water and repeat this procedure with pure tap water.
This will release food that maybe on the underside of the blades. For a thorough
cleaning of the glass jar follow the instructions in the section below.
Thorough Cleaning of the Glass Jar
1. Switch Off, unplug and let the appliance cool down sufficiently.
2. Remove lid and measuring cup from the glass jar. Remove the rubber seal from
the lid.
3. The glass part of the glass jar is mounted on the jar collar by a right-hand
thread. For a better access to the heating plate and blades you may unscrew the
glass part. Grasp the jar collar with one hand and the handle of the glass jar
with the other and twist these parts against each other.
4. Clean glass part, lid, measuring cup, and rubber seal in warm dishwater, using
a soft cloth or nylon brush. These parts can be cleaned in an automatic dishwasher.
