EN
68
ged. Install the central sealing ring at the top of the inner tube. The groove of the
sealing ring must be attached to the rim of the inner tube even and without wrinkles.
3. Push the dark rubber flap at the bottom of the juice collector into the slit of the
pulp outlet. Firmly and evenly press the rubber flap into the slit.
WARNING
– Before operating the appliance, always ensure that the
sealing ring is mounted correctly on the inner tube of the juice collector, and the
pulp outlet is closed correctly via the rubber flap. Also ensure that the exterior of
the juice collector and the shaft of the squeezing auger are clean and dry, before
mounting these parts to avoid that residues of food and liquids get into the motor
base and/or cause leakage of the sealing ring.
4. Place the juice collector on the motor base with the pulp outlet facing to the left.
Align the white marking lines at the bottom of the juice collector and at the top
plate of the motor base (in front of the juicer post). If required, rotate the juice
collector to and fro a little until the juice collector slips down onto the motor base,
coming to a stable stand.
5. Insert the rubber blade sleeve into the juice collector. With the rubber blade
sleeve assembled correctly, the small, dark cogwheel at the bottom of the juice
collector rotates, when turning the rubber blade sleeve.
6. Insert the filter sleeve into the juice collector. On the upper rim of the filter sleeve,
there is a small arrow. Align this arrow with the white marking line at the juicer
post of the juicer base, while pressing the juice collector down gently until it is
mounted stable and cannot be turned.
7. Insert the squeezing auger with the gear rim facing downwards into the filter
sleeve and push the squeezing auger
without violence
down into the filter slee-
ve until the squeezing auger is placed without wobbling in the filter sleeve. If
required, move the squeezing auger to and fro a little to make it settle stably
within the filter sleeve.
NOTE
With the parts positioned correctly, the rim of the filter sleeve protrudes the juice
collector approx. 14 mm and only the upper stainless steel shaft of the squeezing
auger sticks out of the filter sleeve.
CAUTION
–
Do not use violence.
You cannot lock the juicer cover, if there
is still a gap between juicer cover and juice collector. In most cases, the squeezing
auger needs to be pushed down a little deeper. It may help to move the squeezing
auger a little for this.
