Gastops Ltd.
C009423, Rev. 4
page 47
All use of this publication and ChipCHECK by user shall be subject to the restrictions and conditions as set out in this publication.
panels may allow for exposure to Class 4 laser radiation. Such panels include the unit’s side panels,
back panel, and main aluminum wrap. Tamper proof fasteners have been used for your protection.
Only Gastops authorized technicians may remove these fasteners. Users are strictly forbidden from
removing any fastener external to the unit.
6.3 Basic Trouble-Shooting
If you run into any problems with the operation of ChipCHECK, use the trouble-shooting procedures
below in Table 6-1. Should any problem persist, contact your designated customer support
representative (Refer to Section 8.0).
Table 6-1: Basic Trouble-Shooting Procedures
Symptom
Possible Remedy
Software interface does not respond
to user input
•
Conduct a complete unit shutdown and power
down. Then power up and restart the unit as
per Section 3.3.
•
If this does not work, then contact Gastops
Customer Support (See Section 8.0).
Error occurs in software that ceases
use of unit
•
Conduct a complete unit shutdown and power
down. Then power up and restart the unit as
per Section 3.3.
•
If this does not work, then contact Gastops
Customer Support (See Section 8.0).
The unit will not power up
•
Ensure the unit is plugged into an appropriate
100-240 VAC socket and conduct the typical
power up sequence according to Section 3.3.
•
Check and replace the fuse, if necessary (See
Section 6.1.3).
•
If that does not work, then contact Gastops
Customer Support (See Section 8.0).
