USE AND MAINTENANCE
ENGLISH
75
cod. G19502563
PROBLEMS
CAUSES
SOLUTIONS
Seeds too deep.
The seed furrow remains
open and the seeds
uncovered.
Irregular seed drilling
depth.
The gearbox chain jumps
off the gears.
The two pinion axles are not parallel to each
other.
1)
Rear seed-covering wheels a long way from
the seed furrow.
2)
Insufficient pressure of the rear seed-covering
wheels.
3)
Rear seed-covering wheels not suitable for the
ground.
Clod clearer set too low.
1)
Wrong seeding depth setting.
2)
Excessive pressure of the rear seed-covering
wheels.
3)
Unsuitable rear seed-covering wheels.
1)
Correct the depth setting.
2)
Reduce the pressure of the rear wheels on the
ground.
3)
Replace
Raise the clod clearer: it must be set as shown
in the instruction booklet.
1)
Adjust the distance between wheels.
2)
Increase the pressure of the rear wheels on
the ground.
3)
Replace
Loosen the 3 axle fixing bolts and adjust the
position of the axle support.
1)
See distribution table and correct.
2)
Protract the values of the table to the new
specific gravity.
3)
Dusty products are not suitable for this type of
distribution. Change product.
4)
Check the length, shorten them and straighten
them. Cleaning.
5)
Cleaning
6)
Cleaning
7)
Check the position (a gap of about 1 cm must
remain on the back).
8)
Increase the penetration power of the disc and
ballast the seed drill frame.
1)
Clean the exchange valve and the nipple with
calibrated hole fitted on the hydraulic cylinders
of the row marker arms (where present).
2)
Work on the flow regulators to correctly set the
system during the upward movement of the row
marker arms.
1)
Impurities present in the hydraulic system.
2)
The row marker arms rise too quickly (damage
to the structure).
1)
Wrong setting of the MINIMAX distributor and/or
gear ratios.
2)
Product with specific gravity different to those
indicated in the table.
3)
Use of non-granulated product (dusty).
4)
Delivery tube bent sharply and/or blocked by
deposits.
5)
Obstructed furrower element.
6)
Distributor dirty with deposits.
7)
Protective grille fitted the wrong way round (after
maintenance).
8)
Fertilizer on surface.
Irregular distribution of
chemical products
(Fertilizers and
Microgranulates)
Row marker does not work
or works irregularly.
6.0 DEMOLITION AND DISPOSAL
This operation is to be carried out by the customer.
Before demolishing the machine, you are advised to carefully check its physical condition and ascertain whether there are any parts
of the structure that may be susceptible to structural collapse or breakage during demolition.
The customer should operate in compliance with the environment protection laws in force in his/her country.
CAUTION
The machine demolition operations should be carried out by skilled personnel only, equipped with suitable protective clothing
(safety footwear and gloves) and auxiliary tools and equipment.
All the disassembly operations for demolition should be carried out with the machine stopped and detached from the tractor.
Before demolishing the machine, you are advised to render harmless all the parts that may be a source of danger and therefore:
- scrap the structure using specialized firms,
- remove any electrical apparatus according to the laws in force,
- collect oils and greases separately, to be disposed of through specialized firms, in accordance with the regulations of the country
in which the machine was used.
When the machine is demolished the CE mark should be destroyed together with this manual.
Last but not least, we remind you that the Manufacturer is always available for any and all necessary assistance and spares.