Gasmate Ignite BQIG10, Manual, Page: 4 / 16

4 5
GENERAL ASSEMBLY
Connecting & Disconnecting to
the gas source
Familiarise yourself with the general information
and safety guidelines located at the front of this
manual.
Check:
1. The cylinder is filled. A sloshing sound will be
heard when shaken.
2. The burner controls are in the ‘OFF’ position
Connecting:
1. Ensure cylinder valve is in its full off position.
2. Check for any damage to either the cylinder
connection or the hose. NEVER attempt to use
damaged equipment.
3. When connecting the hose to the cylinder
tighten the nut to a positive stop by hand
or spanner.
4. Open cylinder valve fully. If a leak can be heard
at either end of the hose turn cylinder off and
tighten joint with a spanner. Wait 5 minutes
before re-testing and use a soapy water
solution to check the joint. If bubbles appear,
the connection will need to be re-tightened.
IMPORTANT
• Before connecting and disconnecting barbecue
to gas source, make sure burner controls are
in ‘OFF’ position.
•
Caution: When the barbecue is not in use,
the gas must be turned off at the cylinder.
• Important: The appliance control knob must
be in the ‘OFF’ position before opening the
cylinder valve.
• Check performance of burner prior to
installing barbecue plates.
• Do not smoke when attempting to ignite
the barbecue.
• Never use volcanic rock, heatbeads or
other material.
• Always use protective gloves when handling
hot components.
• Note: If for some reason, ignitor fails to
produce a spark at the electrode, barbecue
can be lit by a long barbecue match. With
hood open insert lighted match into match
lighting hole positioned on the side of the
BBQ body. Push and turn a control knob to
‘HIGH’. Burner ignition can be checked
through this hole.
Problem Possible Reason Solution
Burner will not ignite Valve on cylinder is closed Open valve on cylinder
Control knob is closed Turn knob to high when lighting
Igniter is faulty Use a long barbecue match
Ignition system check
Disconnecting:
1. Ensure the burner control is in the
‘OFF’ position.
2. Ensure cylinder valve is in the full off position.
For storage and cylinder exchange, disconnect
hose at the cylinder only, DO NOT disconnect hose
from appliance.