MDE-4813D CFN PLUS Installation Manual
·
February 2018
18
“Flammable and Combustible Liquids Code”, NFPA 30A “Code for Motor Fuel Dispensing
Facilities and Repair Garages “National Electric Code (NEC
®
)”, federal, state and local codes
and any other applicable safety codes and regulations.
System power may come from more than one source. Disconnect all power sources,
including pumps, before attempting to work on the system.
Install the CFN PLUS in an area in accordance with the safety restrictions as shown in
CFN PLUS site preparation is in the customer’s responsibility.
Do not connect power to the CFN PLUS and other peripherals in the whole system,
including pumps, until complete installation is inspected and certified.
Do not perform any metal work in the hazardous area. Sparks generated by drilling,
tapping, and metal work operations could ignite fuel vapors and flammable liquids,
resulting in death, serious personal injury, property loss and damage to you and other
persons.
When working in any open area of Home Base Station, beware of passing vehicles that
could hit you. Block off the work area to protect yourself and other persons. Use safety
cones or other signaling devices.
2
2
-
-
3
3
.
.
C
C
O
O
N
N
D
D
U
U
I
I
T
T
S
S
L
L
A
A
Y
Y
O
O
U
U
T
T
/
/
I
I
N
N
S
S
T
T
A
A
L
L
L
L
A
A
T
T
I
I
O
O
N
N
S
S
P
P
E
E
C
C
I
I
F
F
I
I
C
C
A
A
T
T
I
I
O
O
N
N
S
S
The installation of the CFN PLUS requires preparing beforehand the cables layout in the Home
Base Station. This procedure consists of installing conduits within the station, inserting the proper
cables and setting the proper power equipment and sensors.
This chapter provides the procedures for infrastructure groundwork. These procedures consist of, in
a descending order of performance:
•
Wire conduits installation
•
Cables routing within the conduits
•
Power equipment setup
•
Forecourt equipment wiring
2
2
-
-
4
4
.
.
C
C
O
O
N
N
D
D
U
U
I
I
T
T
S
S
2-4.1. General
The installation of the CFN PLUS in the station requires digging and setting several conduits in the
Station ground. The conduits are required for the routing and protection of the different types of
cables in use in a Home Base Station with CFN PLUS.
In sites where the infrastructure is already set up, you can use the existing conduits only if they
meet the requirements defined below.
