SERVICE SCHEDULE 9
31
after every race
Every 40 operating hours
Every 30 operating hours
Every 20 operating hours
Every 10 operating hours
After 1 operating hour
Check the antifreeze and coolant level. (
○
●
●
●
●
●
Check the cables for damage and for routing without kinks.
●
●
●
●
●
Check that the throttle cables are undamaged, routed without kinks, and set correctly.
○
●
●
●
●
●
Clean the air filter and air filter box.
●
●
●
●
●
Change the glass fiber yarn filling of the main silencer.
●
●
Service the fork.
●
Perform the shock absorber service.
●
Check the tightness of the easily accessible, safety-relevant screws and nuts.
○
●
●
●
●
●
Change the fuel screen.
○
●
●
●
●
●
Check the fuel pressure.
●
●
●
●
●
Check the idle speed.
○
●
●
●
●
●
Final check: Check the vehicle for operating safety and take a test ride.
○
●
●
●
●
●
Read out the fault memory after the test ride using the GASGAS Motorcycles diagnostics
tool.
○
●
●
●
●
●
Make a service entry in
GASGAS Motorcycles Dealer.net
.
○
●
●
●
●
●
○
One-time interval
●
Periodic interval
9.3
Recommended work
every 48 months
every 12 months
Every 100 operating hours
Every 50 operating hours
After 20 operating hours
After 10 operating hours
Change the front brake fluid.
●
●
Change the rear brake fluid.
●
●
Change the hydraulic clutch fluid.
●
●
Lubricate the steering head bearing.
●
●
Service the fork.
○
Perform the shock absorber service.
○
Change the fuel filter.
●
Change the coolant. (
●
Perform minor engine service, engine has been installed. (Change the spark plug and spark
plug connector. Change the piston, check and measure the cylinder; check the cylinder
head. Check the camshaft, rocker arm and rocker arm shafts. Check timing assembly.)
●
●
Perform major engine service including removing and installing the engine. (Change valves,
valve springs, valve spring seats, and valve spring retainers. Change the connecting rod,
conrod bearing and crank pin. Check the transmission and the shift mechanism. Check the
oil pressure control valve. Change the suction pump. Check the force pump and lubrication
system. Change the timing chain. Change all engine bearings. Change the radial shaft seal
rings and bearing seals of the main bearing.)
●
