18 CLEANING, CARE
112
18.1
Cleaning the motorcycle
Note
Material damage
Components become damaged or destroyed if a pressure cleaner is used incorrectly.
The high pressure forces water into the electrical components, connectors, throttle cables, and bearings, etc.
Pressure which is too high causes malfunctions and destroys components.
–
Do not direct the water jet directly on to electrical components, connectors, throttle cables or bearings.
–
Maintain a minimum distance between the nozzle of the pressure cleaner and the component.
Minimum clearance
60 cm (23.6 in)
Note
Environmental hazard
Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the appli-
cable regulations.
Info
To maintain the value and appearance of the motorcycle over a long period, clean it regularly.
Avoid direct sunshine when cleaning the motorcycle.
401061-01
–
Close off exhaust system to keep water from entering.
–
Remove loose dirt first with a soft jet of water.
–
Spray the heavily soiled parts with a normal commercial motorcycle
cleaner and clean using a brush.
Motorcycle cleaner (
Info
Use warm water containing normal motorcycle cleaner and
a soft sponge.
Never apply motorcycle cleaner to a dry vehicle; always
rinse the vehicle with water first.
–
After rinsing the motorcycle with a gentle spray of water, allow it to
dry thoroughly.
–
Remove the closure of the exhaust system.
Warning
Danger of accidents
Moisture and dirt impair the brake
system.
–
Brake carefully several times to dry out and remove dirt
from the brake linings and the brake discs.
–
After cleaning, ride the vehicle a short distance until the engine
warms up.
Info
The heat produced causes water at inaccessible locations in
the engine and on the brake system to evaporate.
–
Push back the protection caps of the handlebar controls to allow any
water that has penetrated to evaporate.
–
After the motorcycle has cooled down, lubricate all moving parts
and pivot points.
–
Clean the chain. (