background image

Axiom Carton Contents

4

The 

Axiom 

is packaged with the following parts, some partially assembled. If any part is missing, please 

contact Garrett Customer Service.

Stem assembly with  
mounted control box

Warranty card

Upper and lower stem

Searchcoil with coil cover installed

USB-C charging cable

Quick-Start Guide

Note: Full Axiom user’s 

manual is available on 

garrett.com in multiple 

languages

MS-3 Wireless headphones 
and Micro-USB charging cable

Wall charger and adaptors

Note: headphone type may vary by package

Note: Searchcoil types  

and sizes vary according to 

package purchased

12V cigarette to alligator cables 

and USB to cigar adaptor

Optional item in some kits

Soft carry case

Axiom booster pack

Bolt, mounting washers

Quick Start Guide

ASSEMBLY 

  This device complies with part 15 of the FCC Rules. 
Operation is subject to the following two conditions: (1) 
This device may not cause harmful interference, and (2) this 
device must accept any interference received, including 
interference that may cause undesired operation. 
  Changes or modifications not expressly approved by 
the party responsible for compliance could void the user’s 
authority to operate the equipment.
  This device complies with Industry Canada license-exempt 
RSS standard(s). Operation is subject to the following two 
conditions: (1) this device may not cause interference, and 
(2) this device must accept any interference, including 
interference that may cause undesired operation of the 
device.

   Ce produit est conforme aux normes RSS exemptes de 
licence d’Industry Canada. Son fonctionnement est soumis 
aux deux conditions suivantes : (1) ce dispositif ne peut pas 
provoquer d’interférences et (2) ce dispositif doit accepter 
toute interférence, y compris celles pouvant entraîner un 
dysfonctionnement. 

Wireless Transmitter Specifications

Audio Delay:     17 milliseconds
Audio Bandwidth:   30-18,000 Hz
Operating Frequency:  2406–2474 MHz
Transmit Power:   8.6 dBm EIRP
Certifications:   

  FCC, CE, IC, AS/NZ

Release clamp, extend lower stem. Press the mounting 
washers into place.

Insert lower stem into 
searchcoil bracket.

Insert bolt, and hand- 
tighten wing nut.

Wrap cable around stem, with the first 
turn of cable over the stem. Attach to 
back of control box, tighten collar.

REGULATORY INFORMATION / INFORMACIÓN NORMATIVA / INFORMATIONS RÉGLEMENTAIRES

© 2022 Garrett Electronics, Inc. PN 1557400.A.0522

Click to access detailed 

Axiom

 guides in other languages.

Cliquez pour accéder aux guides Axiom détaillés dans d’autres langues.

QUICK START

3 feet (1 m) per second at 1/2 inch (1.25 cm) above ground

Power ON. Set Sensitivity, 
Threshold and Volume.

Perform Frequency Scan (if needed to eliminate EMI). 

Ground Balance  
(if needed to  
eliminate ground  
response). 

Begin 
scanning.

Lengthen lower stem 
until it snaps into place. 
Adjust upper stem.

BATTERY CHARGING

12V battery terminal charging with optional 
cables. Charge time: 10 hours approx.

ADJUSTING ARM CUFF

Use hexnut wrench 
(stored below cuff ) 
to remove four 
screws.

Move cuff up to 
two slots forward 
or backward (at 
least 2 bolts must 
be secured).

Clip 

Axiom

 Booster Pack into the 

stand below the detector cuff.

Axiom

 Booster pack uses eight 

(8) AA akaline or NiMh batteries. 
Note proper polarity direction.

P

Use supplied 3-amp USB wall charger. 
Charge time: 7 to 8 hours approx.

Plug cable into the USB 
connector on back of 

Axiom

.

ىرخلأا ةغللاب ةحضولما مويسكا ةلدأ لىع لوصحلل طغضا

1557400.A.Axiom Quick Start Guide.indd   1

1557400.A.Axiom Quick Start Guide.indd   1

6/17/2022   12:59:01 PM

6/17/2022   12:59:01 PM

Model Name:

Serial Number:

Garrett Metal Detectors Warranty

Sport Division

Garrett Electronics, Inc. (“Garrett”) warrants that each piece of detection equipment 
manufactured by Garrett is protected by the following limited parts and labor warranty for a 
period of 24 (twenty-four) months from the date of purchase. During this 24-month period 
Garrett will inspect and evaluate all equipment returned to its authorized repair station or 

factory to determine if the equipment meets Garrett’s performance specifications. Garrett 

will repair or replace at no charge to the owner all parts determined faulty. This Warranty 
does not cover batteries nor any and all failures caused by abuse, tampering, theft, failure 
due to weather, battery acid or other contaminants and equipment repairs made by an 
unauthorized party.

THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED 
OR IMPLIED, INCLUDING THE WARRANTY OF MERCHANTABILITY OR FITNESS 
FOR A PARTICULAR PURPOSE. THE BUYER ACKNOWLEDGES THAT ANY ORAL 
STATEMENTS ABOUT THE MERCHANDISE DESCRIBED IN THIS CONTRACT MADE 
BY SELLERS’ REPRESENTATIVES, IF ANY SUCH STATEMENTS WERE MADE, DO  
NOT CONSTITUTE WARRANTIES, SHALL NOT BE RELIED UPON BY THE BUYER, 
AND ARE NOT A PART OF THIS CONTRACT FOR SALE. THE ENTIRE CONTRACT IS 
EMBODIED IN THIS WRITING. THIS WRITING CONSTITUTES THE FINAL EXPRESSION 
OF THE PARTIES’ AGREEMENT AND IS A COMPLETE AND EXCLUSIVE STATEMENT 
OF THE TERMS OF THIS AGREEMENT.

The parties agree that the Buyer’s sole and exclusive remedy against Seller shall be for 
the repair and replacement of defective parts. The Buyer agrees that no other remedy 

(including, but not limited to, incidental or consequential damages for lost sales, lost profits, 

injury to person or property) shall be available to him.

Special Notice to Foreign Customers:

 Terms of this Warranty may vary depending on the 

country in which this equipment was purchased and delivered. Any claims based on this 
Warranty must be made to Garrett’s local representative or agent. Do not attempt to return 
any Garrett products to the factory in the United States without written authorization from 
Garrett’s local agent or representative.

1562400.I.0121

Summary of Contents for Axiom



























Reviews: