Page 14
810-PS2 Manual
4. Make up an anchor by cutting a 4” X 16” piece of 1/4” thick
material. Bend each end down at 90 degrees (see the diagram
below), so the resulting flat piece is about 4” X 10” inches with
3” sides. Drill a hole to insert a 2”ID schedule 40 pipe in the
center of the plate, weld tube to plate. Insert the bar into the
tank and slide the anchor assembly over the sensor bar with
the “U” facing down. Align the sensor bar vertically and weld
the anchor in place to the bottom of the tank. Pull the sensor
bar up a bit and slide the float (cone side up) over the bar.
Lower the bar back into the anchor.
5.
Tighten the base of the compression fitting into the coupler.
Lift the bar at least 2” off the bottom of the tank, and tighten
down the compression fitting nut. Raise and lower the float a
few inches to set the bottom reading.
6. Pick a spot for the display. It should be easy to reach and out
of direct road spray. Put a bead of non-hardening sealant
around the perimeter of the display enclosure and mount the
enclosure using the mounting flange holes and 1/4” locking
hardware. Make sure that the enclosure is mounted so that
the fitting hole is on the correct side (the front panel will fit
either way).
7. Route 1/4” Nylon air brake hose from the sender head to
the display and fasten with brass inserts and compression
fittings at each end (the brass inserts may be part of the
fitting). At the lowest point in the air line insert a T fitting
with approximately two feet of Synflex hanging down to
provide a drain for any water than may get into the system. If
a T fitting is not feasible, put a fitting into the bottom of the
Summary of Contents for SeeLevel ProSeries II 810-PS2
Page 30: ......
