Put cylinder Rod Eye block (
item 31
) down over the pin in the Rod Eye Mounting Bracket (
item 4
). See
Figure 11-a. Turn the Cylinder (
item 34
) so that the Fittings (
item 35
) point up (toward the top of the
motor). Line the hole in rear end cap of the Cylinder (
item 34
) with the hole in the top of the Stern Pivot
Pin (
item 5
). Slide the Clevis Pin (
item 14
) into the top hole of the Stern Pivot Pin. Line up the cross holes
and put the Large Hair Pin Cotter (
item 12
) through the cross holes in both Pins. See Figure 11.
NOTE: If for any reason you
need to disconnect the steering
actuator, pulling the large Hair
Pin Cotter and Clevis Pin will
disconnect them quickly.
Install the Hair pin
(item 13)
on the pin in the
Rod Eye Mounting Bracket (
item 4
) and against
the Rod Eye block (
item 31
). See Figure 12.
Page 6
Figure 12
Step Four:
Figure 11
Step Five:
Figure 11-a
