Put a little thread locker on the second 8MM
(
item 8
) bolt and install it through the other Lock
Washer (
item 9
), the sandwich of the Cylinder
Mounting Channel (
item 6
) and Doubler Plates
(
item 7
) created at Fig. 6, the upper Short Standoff
(
item 2
), and into the upper motor vibration
isolation mount. Keep the Channel perpendicular
to the motor down shaft and tighten the bolt.
Slide the small end of the Stern Pivot Pin (
item 5
) through
the holes at the rear of both flanges. Secure the Pivot Pin
in place by inserting a Medium Hair Pin Cotter (
item 13
)
through the hole below the bottom flange. See Figure 9.
Figure 8
Figure 9
Figure 10
Page 5
Install the Rod Eye Bracket
(item 4)
by putting
the lower channel flange against the top of the
motor grease fitting boss (as shown in Fig. 10),
slide in the “U” Bolt (
item 10
), put on the Lock
Washers (
item 11
), a little thread lock, and screw
on and tighten the nuts.
Step Two:
Step Three:
